Back to Topic List

CD LINE SYSTEM CONTROLS 2

By Thomas Shevels

ADJUST CUSTOM RHYTHM AUTO-TEMPO

Start Rhythm   ENTER < ENTER ENTER >> ENTER > [adjust speed with: < slow or > fast] EXIT EXIT EXIT EXIT                                                                                                      
 

EDIT A SOUND

ENTER <<<<< ENTER < ENTER [move reverb drbar]  ENTER EXIT EXIT

 

STORE CUSTOM SOUNDS ON CV MEMCARD

Insert CV Card   ENTER CENTRE YES  > ENTER EXIT EXIT

STORE ONE CUSTOM PRESET MIX ON CV MEMCARD

[Insert CV Card]  Set Mixture  ENTER  ENTER  ENTER [press memcard button; press a PRESET button] ENTER EXIT
 

STORE ONE CUSTOM SOUND ON CV MEMCARD

Insert CV Card   ENTER > ENTER << ENTER  [press memcard button; press a PRESET but.] ENTER EXIT EXIT

                       

STORE RHYTHM + ACCOMP. ON CV MEMCARD

Insert CV Card     ENTER CENTRE >> ENTER > ENTER EXIT EXIT

MEMCARD WRITE PROTECT ON

ENTER CENTRE < ENTER  ENTER EXIT EXIT

MEMCARD WRITE PROTECT OFF

ENTER CENTRE < ENTER < ENTER EXIT EXIT

SYSTEM PARAMETER CONTROLS

ENTER SYS.PARAMETERS SECTION WITH:

                          ENTER >>>ENTER  [Displays PED.POLY 1st]  Press > to find required item:

ITEM                                                    DEFAULT       <> TO ADJUST then ENTER to set. 

                                                                          
PED. POLYPHON [=>PRESET]          OFF                 ON  =  Makes pedals polyphonic
FOOTSW VIA PRESET                      OFF                 ON  =  Footsws controlled by Presets
LM SPLIT VIA PRESET                     OFF                 ON  =  Split Point controlled by Presets

WV SPEEDSHIFT                              ON                 OFF =  Cancel WV whirl windup/down
CANCEL BEFORE RUN                    OFF                 ON  =  Clip sustain when playing each note
SOLO VOICE DELAYED                   OFF                 ON = Add short sustain to  lower solo vce
TOUCH SENSITIVITY                          4                   Set Touch value [using Reverb DBar]1˜8
U/M CHORUS AUTO OFF                  ON                 OFF  =  cancel U/M Chorus & Chan 2+3
REVERB TYPE                                 DH11               Select either DH11 or DH100 Reverb

SET FOOTSW DETUNE                     /                     Only used for 3 FTSW models
U/M ALL PITCHBEND                     OFF                  ON =  add Pbend to all 3 UM Cust Selectrs
[Some of these will cause REVERB LED to flash - use Reverb DBar for adjustments.]

SYSTEM INITIALIZE

ENTER             STANDARD PARAMETERS.                      RESET  to above default values
>                      RAM FORMAT: ALL DATA LOST!              CLEARS RAM COMPLETELY
EXIT                until clear.